1. Click on "My Computer"
2. Click on "Dial-Up Networking"
(Unless you have service with another Internet Service Provider, you should see only 2
icons: "Make New Connection,"
and "Show-Me Net." If you have
any unwanted icons, just RIGHT-Click on each, click on "Delete,"
and click "Yes" you are sure.)
3. RIGHT-Click on Show-Me Net's icon (If you do not have a Show-Me Net
icon, click on "Make New Connection" and follow the instructions. If you
don't know the answers -- guess. After you click "Finish," Right-Click on
the new icon and continue these instructions.)
4. Left Click on "Properties" All
of the settings are in this section. The ONLY changes or additions necessary are:
-- Enter the telephone number that you want to dial. DO NOT CALL
LONG DISTANCE! Jackson 204-0040; Benton 545-3922; Perryville 517-0400; Pocahontas
(call forwarding only) 833-6030.
-- Remove the check mark in the box next to: "Use area code and dialing
properties" or "Use country code and area code."
-- Verify that the "Connect using:" box lists your modem. If in doubt,
assume it is correct.
-- NEVER click on the "Configure:"
button and change anything!
-- Click on the "Server Types"
tab or button.
-- The type of Dial-Up server is "PPP...."
-- The ONLY boxes checked should be "Enable software
compression" and "TCP/IP"
Un-check all others on this page.
-- Click the "TCP/IP Settings"
button
-- Make sure that "Server assigned IP address" is
selected.
-- Select "Specify name server addresses"
-- Enter the Primary DNS: 204 . 184 . 146 .
253
-- Enter the Secondary DNS: 150
. 199 . 178 . 1
Show-Me Net should work if you do not change any other settings. If your connection does not work, try deleting it and set it up again. Just click on "Make New Connection" and answer the questions. Then, follow steps 3 and 4 to "fine-tune" the setup. If it still doesn't work, ask a computer knowledgeable friend for help, or call Show-Me Net's Help Desk, 204-1097.
This page was last modified May 24, 2000.
http://www.showme.net/helpdesk/setup.htm